Shortly after purchasing and installing bar end mitts last winter I wrote an article about my first impressions. I continued to use them all of last winter and removed them come Spring. I put them back on a few weeks ago assuming I would continue to use them this winter but about a week ago I took them back off as I decided to try something different. What I am trying to say is I no longer have the same impression of them as I had when I first wrote about them.
They do block the wind which is appreciated. However, they are just too small and there is not enough room inside of them. My hands are not only right up against them which means the cold is transferred thru whatever gloves or mittens I wear and causes my handwear not to work as well as it would and can without this scenario. And because they are too small inside I am limited as to what handwear I can use. In addition to these problems it is nearly impossible for me to twist my twist shifters to shift gears. Working the brake levers is even challenging.
So I made the decision to remove them and just wear my Hotfingers Rip N Go mittens which do a good job of blocking the wind and air from passing thru them. Mittens are a bit cumbersome but I can shift and work my brake levers with them.
If needed I can also wear my hand knit wool mittens inside of the Hotfinger mittens which is warmer yet.
And I can use chemical hand warmers inside of either pair of mittens if needed. It has been working quite well for me … much better than using the bar end mitts.
As an update … I have discovered the best combination for me thus far. I have removed the wool mittens from inside of the Hotfinger mittens and am using the chemical hand warmers inside of the Hotfinger mittens. My thumbs were getting cold so by doing this there is room enough inside of the thumbs of the Hotfinger mittens to place chemical hand warmers and keep my thumbs warm. Of course, I am using twice as many of the hand warmers by doing this but at least my entire hands are staying warm.
I know that there are bar end mitts made for ATVs , snowmobiles and motorcycles which are larger and might be okay. I will keep this in the back of my head in case I need to go that route. I have to admit I am skeptical as to whether or not they would be large enough to eliminate the issues I have with these I already bought. Meanwhile I will continue on with what I am doing now and hope I am done with bar end mitts. They are ugly looking when installed anyway. I think I am going to be able to …
ENJOY THE RIDE
KEEP ON TRIKIN’
using my mittens. Now if I could just find a mitten for my nose.
A FREE GIFT awaits you!