TERRACYCLE FLAG MOUNT

TerraCycle is well known for high quality products for us cyclists. Their flag holder (mount) is no exception. It is definitely more expensive than other flag holders I have seen ($38) but hey it is really well made and will definitely do a superb job of holding a flag pole. As you can see it is easy with this mount to adjust the angle forward to back of the flag pole (or even sideways if you have the mount positioned sideways on the trike).

It is available for both 1/4 inch and 6 mm flag poles. The mounting clamps are available in 1/2 thru 1 1/4 inch diameter or you can order it without any clamps. To order their flag pole mount click HERE

With these mounts the flag can be placed various places  … rear stays, seat frame … anywhere that will work for you. I highly recommend not having your flag pole positioned where people can get their eye poked out riding or walking into it. I see this all the time … flag poles that pose a serious threat of injury of others. Be considerate of others and think about what you are doing. Don’t be part of the problem. Wouldn’t you feel terrible if you were the cause of somebody losing their eye?

Personally I remove my two flags after each ride so I need a system which is easy and quick to do this. My Catrike flag pole holders work great for me but I had to come up with my own mounting system which wasn’t hard to do

If you have not come up with what works for you or if you want to possibly improve what you have consider these TerraCycle flag mounts.

KEEP ON TRIKIN’

A FREE GIFT awaits you!

3D PRINTING … A HANDY GADGET

Over the last few years I have been seeing everything from a small part to an entire bicycle which was created by 3D printing. I don’t profess to know the first thing about 3D printing but as a metal fabricator most of my life I find it interesting and intriguing that various things I have always made out of metal can be made out of plastic and function quite well. I understand that the plastic used is quite inexpensive and is lightweight.

Here are some 3D printed mounts for taillights one tadpole rider has made for his tadpole trike:

 

Below is the mount made for the camera on a telescoping selfie stick.

Below is a water bottle holder.

As you can see all sorts of stuff can be made using a 3D printer. I would have to say however that for the average person it would not be all that practical to have such equipment. First of all it is expensive to buy so unless one would use it a lot it just would not be justifiable. And most of us probably would not be savvy enough to be able to use it. Lastly, most of us probably would not find ourselves needing to make all that much stuff for our trikes. What little we might have come up we can buy for a lot less than the 3D printer and supplies would cost. But for those interested and able it is an option.

May we all manage to …

KEEP ON TRIKIN’

FREE GIFT awaits you!